Automatic Update Of The Drivers; Updating Or Deinstalling The Older Driver Version - WIKA CPT2500 Betriebsanleitung

6. USB-ScanSoft software
5. Plug the model CPA2500 adapter into the USB port of the PC.
⇒
The CPA2500 is now automatically installed with the current driver.
Through the installation of the driver, the CPT2500 USB pressure sensor, in connection
with the CPA2500 USB adapter, can be communicated with via a COM port.
The current interface driver can also be found on our website www.wika.
com

6.2.2 Automatic update of the drivers

An older driver that was previously installed in the system will not be automatically
updated.
If, during the installation of the instrument, it is detected that there is already a driver that
is suitable, from the operating system's point of view, this driver is automatically used.
If problems occur when using the adapter, first make sure that the current
driver for the adapter is also being used. If necessary, the current driver
must be installed manually, see chapter 6.2.2 "Automatic update of the
drivers")

6.2.3 Updating or deinstalling the older driver version

In order to update a driver, the "old" driver must first be deinstalled and then the new
driver installed.
Deinstalling the driver
1. Disconnect the connections to USB adapter.
2. Call up the item Software.
⇒
Start \ Settings \ System control
3. Open the sub-item Connections (COM and LPT).
4. Find the entry CP210X USB to UART Bridge Controller in the program list.
5. Press [Change/Remove].
6. Confirm the deinstall warning.
⇒
The deinstallation is now carried out.
7. Then acknowledge the corresponding success message.
⇒
The driver is thus deinstalled for all respective USB adapters.
Reinstallation of the driver
▶
The reinstallation is carried out in line with the installation instructions. Please
continue reading there at your operating system.
WIKA operating instructions, models CPT2500, CPA2500 and USB-ScanSoft
EN
19