Standard Equipment; Machine Assembly; Mounting On Stands; Mounting On Bench - RIDGID 300 Compact Bedienungsanleitung

300 Compact/1233 Threading Machines

Standard Equipment

Refer to the RIDGID catalog for details on equipment
supplied with specific machine catalog numbers.
The Threading Machine serial number plate is located
on the end of the base or the back of the base. The last
4 digits indicate the month and year of the manufacture
(MMYY).
XXXXXXXXMMYY
Figure 3 – Machine Serial Number
NOTICE Selection of appropriate materials and instal-
lation, joining and forming methods is the responsibility
of the system designer and/or installer. Selection of
improper materials and methods could cause system
failure.
Stainless steel and other corrosion resistant materials
can be contaminated during installation, joining and
forming. This contamination could cause corrosion and
premature failure. Careful evaluation of materials and
methods for the specific service conditions, including
chemical and temperature, should be completed before
any installation is attempted.

Machine Assembly

WARNING
To reduce the risk of serious injury during use,
follow these procedures for proper assembly.
Failure to mount the threading machine to a stable
stand or bench may result in tipping and serious
injury.
REV/OFF/FWD switch should be OFF and machine
unplugged before assembly.
Use proper lifting techniques. The RIDGID 300 Com­
pact weighs 141 lb (64 kg) and the 1233 weighs
165 lb (75 kg).
6

Mounting on Stands

The Threading Machines can be mounted on various
RIDGID Threader Stands. Refer to RIDGID catalog for
stand information and to the respective Stand Instruction
Sheet for mounting instructions.

Mounting on Bench

The machines can be mounted on a level, stable bench.
To mount the unit on a bench, use four
in holes provided at each corner of the machine base.
Base hole spacing is 12.25" × 18" (311 mm x 457 mm).
Tighten securely.

Mounting on Pipe Legs

Four equal lengths of 1" (25 mm) pipe can be used as a
stand for both the machines. Pipes cut to 33" (0.84 m)
length will place the machine rails approximately 36"
(0.91 m) off the ground. Fully insert the pipes into leg
sockets provided on the underside of the base at the
corners. Secure with four provided 10 mm hex bolts
through the base. See Figure 4.
Figure 4 – Threading Machine Mounted On Pipe Legs
/ " - 20 UNC bolts
1
4
Secure
Legs with
Hex Bolts
999-998-098.08_REV C