Safety Instructions - Electrolux EH6L40CN Benutzerinformation

similar accommodation where such use does not exceed
(average) domestic usage levels.
Only a qualified person must install this appliance and
•
replace the cable.
Do not use the appliance before installing it in the built-in
•
structure.
Disconnect the appliance from the power supply before
•
carrying out any maintenance.
If the mains power supply cable is damaged, it must be
•
replaced by the manufacturer, its Authorised Service Centre
or similarly qualified persons to avoid an electrical hazard.
The control panel must be connected to specified heating
•
unit with matching colours of connectors, to avoid possible
hazard.
The means for disconnection must be incorporated in the
•
fixed wiring in accordance with the wiring rules.
WARNING: Ensure that the appliance is switched off before
•
replacing the lamp to avoid the possibility of electric shock.
WARNING: The appliance and its accessible parts become
•
hot during use. Care should be taken to avoid touching
heating elements.
Always use oven gloves to remove or insert accessories or
•
ovenware.
To remove the shelf supports first pull the front of the shelf
•
support and then the rear end away from the side walls.
Install the shelf supports in the opposite sequence.
Do not use a steam cleaner to clean the appliance.
•
Do not use harsh abrasive cleaners or sharp metal scrapers
•
to clean the glass door since they can scratch the surface,
which may result in shattering of the glass.

2. SAFETY INSTRUCTIONS

2.1 Installation
WARNING!
Only a qualified person must
install this appliance.
4 ENGLISH
• Remove all the packaging.
• Do not install or use a damaged
appliance.
• Follow the installation instructions
supplied with the appliance.