Receiving Measurements Automatically - Bresser Thermo Hygro Quadro Neo C Bedienungsanleitung

16 Receiving measurements automatically

Once batteries are installed, the base station will display the
measurement readings. Readings from the remote sensor
will be displayed within 3 minutes after powering it on.
17 Display change °C/°F
• Base station
1.
2.
3.
4.
• Wireless sensor
Open the battery compartment.
Press the °C/°F button to toggle between °C and °F.
Close the battery compartment again.
18 Clima indicator
1
1 COMFORT: Optimal (Temperature
between 20-28°C and humidity
between 40% and 70%)
In normal display mode, press the PRESSURE button for
about 3 seconds to enter the settings mode. The sym-
bol for the weather situation flashes.
Press the PRESSURE button again. The temperature
unit indicators flash.
Press the UP or DOWN button to toggle between °C
and °F.
To automatically save the setting made, do not make
any further adjustments for about 5 seconds. The base
station automatically switches back to normal display
mode. Alternatively, press the PRESSURE button several
times until the display stops flashing.
2 3
2 DRY: Humidity >65%
15 / 40