Manual Time Setting; Receiving Measurements Automatically; Weather Trend - Bresser Meteo Temp HZ Bedienungsanleitung

10 Manual time setting

1. Press and hold SET button for approx. 4 seconds to
change to time setting mode.
2. Digits to be set are flashing.
3. Press UP or DOWN button to change the value.
4. Press SET button to confirm and continue to the next
setting.
5. Settings order: Year > Month > Day > Month (M) and
Day (D) / Day (D) and Month) > Time offset (-12 to 12
hours) > 12/24-hour mode > Hours > Minutes
6. Finally press the SET button to save the settings and
exit the setting mode.

11 Receiving measurements automatically

Once batteries are installed, the base station will display the
measurement readings. Readings from the remote sensor
will be displayed within 3 minutes after powering it on.
If no signal will be received, then go ahead with the follow-
ing steps:
1. Press SYNC button for approx. 2 seconds to re-initiate
reception of measurements again.
2. If the device is still not receiving the signal: Press and
hold the DOWN button for approx. 2 seconds to initiate
reception of measurements again.

12 Weather trend

The weather station will calculate a weather trend for the
next 12-24 hours on basis of the measured values.
13 / 32