Manual Time Setting - Bresser ClimaTrend Life Bedienungsanleitung

The current time and date are automatically received and
shown on the display of base station after proper synchron-
ization of the outdoor sensor and base station. This process
may take a few minutes.
Note:
• The outdoor sensor searches for the time signal at 2:00
and 17:00 every day to update the time and date in-
formation.
• Do not place the outdoor sensor and base station near
sources of interference such as TVs, computers, etc.
• Do not place the components near metal plates
• The use in enclosed spaces such as airport buildings,
high-rise buildings or factories is not recommended.
• Reception can be significantly disturbed in vehicles due
to constant movement.
If the automatic reception of the radio signal does not work,
perform a re-synchronization of the base station with the
outdoor sensor to re-initiate the reception of the radio sig-
nal. Please also read the chapter "Finding and connecting a
sensor" for more detailed information. If necessary, find a
new location for the individual components. When doing so,
observe the above notes on reception.
If the reception of the radio signal fails even after several at-
tempts of synchronization, the time and date must be set
manually. To do this, follow the instructions in the corres-
ponding chapter.

11 Manual time setting

1. Press and hold TIME SET button for approx. 3 seconds
to change to time setting mode.
2. Digits to be set are flashing.
3. Press +/CHANNEL or -/MEM button to change the value.
15 / 56