Snooze Function - Bresser Thermo Hygro Quadro Neo C Bedienungsanleitung

14 Snooze function

1.
2.
3.
NOTICE! The snooze function can be reactivated up to seven
times before the alarm is automatically stopped.
15 Change room name
NOTICE! The room name cannot be changed when the time
signal search is active (the corresponding icon flashes). Wait
until the time signal search is completed to be able to
change the room name.
1.
2.
3.
4.
5.
6.
14 / 40
When the alarm tone sounds, press the SNOOZE/LIGHT
button on the top of the base station to activate the
snooze function. The alarm sounds again after 5
minutes.
When the alarm sounds, press any other button to stop
the alarm until the set alarm time is reached again.
If no button is pressed, the alarm is automatically
switched off after 2 minutes.
Press the ROOM button of the desired wireless sensor.
The room name flashes.
Press the ROOM button repeatedly to select one of the
5 preset room names. Alternatively, continue with 3. or
wait approx. 5 seconds until the change has been saved
automatically. The display stops flashing.
Press the UP button to switch to the entry of a free
room designation. "_" flashes.
Press the UP button until the desired input value
flashes. Possible input values: A-Z, 0-9, _ > < / * -
Press the ROOM button again to switch to the next in-
put value and enter it as described under 4.
Finally, press the ROOM button to save the entry. If no
entry is made within 5 seconds, the settings made up to
this point are automatically saved. In both cases the
display stops flashing and the free input is stored.