Bresser Thermo Hygro Quadro Neo C Bedienungsanleitung Seite 10

8 Finding and connecting a sensor
Normally, the connection between the base station and the
sensor is established automatically. However, after a battery
change or in the event of a connection fault, the sensor
search can be triggered manually and thus the connection
re-established.
NOTICE! Before establishing the connection, make sure that
the sensors are set to different channels (1, 2 and 3). The
base station will then display channel 1 as ROOM1, channel
2 as ROOM2 and channel 3 as ROOM3.
1. In normal display mode, long press the [ROOM1],
[ROOM2] or [ROOM3] button for 2-3 seconds to activate the
reception of the sensor signal for the displayed channel.
The signal icon will flash.
2. The signal symbol flashes until the reception is success-
ful. If no signal is received within 5 minutes, the symbol dis-
appears.
9 Set weather status and air pressure above
N.N
NOTICE! The following settings cannot be made when the
time signal search is active (the corresponding icon flashes).
Wait until the time signal search is completed to make the
settings.
NOTICE! These settings should also be made again if the
device location is changed significantly.
NOTICE! Information on the current value for the air pres-
sure above N.N. can be found on the Internet at https://
www.radar-live.com/p/atmospheric-pressure.html
For a correct display of the weather forecast, the current
weather status and the air pressure above N.N. must be set
correctly. The first weather forecast will be displayed ap-
proximately 6 hours after the set-up.
10 / 40