Balluff BIR 01 K12LL3-000S04 Serie Konfigurationsanleitung Seite 137

BIR 01-_ _ _ _-K1_ _ L_... / BIR 02-_ _ _ _-P1 _ _ L _...
Inductive Rapid Positioning System
6
System Functions (continued)
Namur Standard
Name
Device Discovery
Short Circuit Pin 2 / Pin 4
Measurement Error
Failure
Teach-in
Maintenance Required
Functional Check
Overload
Bad Signal Quality
Out of Specification
Function Display
Communication
Ready Diagnosis On
Ready Diagnosis Off
Tab. 6-11: LED meaning and configuration – Namur Standard
www.balluff.com
Signal
Blue flashing, 3 Hz
Red flashing, 3 Hz
Red flashing, 1 Hz
Red, static
Red, static
Blue, static
Orange, static
Orange flashing, 3 Hz
Orange flashing, 1 Hz
Yellow flashing, 3 Hz
Yellow, static
Green, alternating with LED off in a
ratio of 10:1, 1 s period
Green, static
Static white
Meaning
The Device Discovery can be activated via a system
command to find the device again.
Short circuit at pin 2 or pin 4
This signal occurs if a measurement error occurs. The
measurement value is unknown due to an error or
outside of the measuring range.
General error
The device is currently in teach-in mode
Maintenance must be performed.
The device is currently being parameterized/adjusted.
Measurement is not currently possible.
Overload on pin 2 / pin 4 has been detected.
Poor signal quality, the signal quality is below the
configured warning threshold.
The device is operated outside of specifications. A
reliable measurement signal can no longer be ensured.
The object was detected. / Switching point is active.
IO-Link communication is active. The device is ready.
The device is ready. Diagnosis functions are on.
The device is ready. Diagnosis functions are switched off.
english 65