Reading The Energy Meter - ABL Wallbox eM4 Twin Bedienungsanleitung/Sicherheitshinweise

4
Open your domestic power distribution box, disconnect
the wallbox's power supply cable from the electricity
grid via the MCB, secure the MCB against being
switched on again and close the distribution box.
The eM4 Twin Wallbox is no longer connected to the electricity grid and can be removed by a qualified specialist
electrical contractor if required.

Reading the energy meter

Each charging point of the eM4 Twin Wallbox has its own energy meter that shows various information about the
charging operation via the three display lines. In contrast to the top line, the values displayed in lines 2 and 3 are
switched cyclically:
A
Total electric energy consumed
B
The top line always shows the total electric power con-
sumed in kWh, and therefore the sum of all the electrical
C
charge obtained via this particular charge point. This line
is not switched.
D
A
E
B
Current electric energy consumed
F
C
In this state, the second line shows the active energy in
kWh that has been drawn so far during the active charging
A
D
operation.
B
E
C
F
Charge point allocation
D
After switching, the second line in this state shows the
identification that was assigned to the charge point during
E
installation.
F
A
B
C
D
A
Duration of the charging operation
E
After switching, the second line in this state shows the
B
duration of the active charging operation in hours, minutes
F
C
and seconds.
D
E
Current electric power consumption
F
In this state, the third line shows the active power that is
currently being drawn by the vehicle: During charging, the
value varies dynamically; without a vehicle connected, the
value is 0.0 kW.
eM4 Twin Wallbox – Reading the energy meter | 25
1
0
A
B
A
C
A
D
E