Setting Up; Configuration - Beyerdynamic MCS Bedienungsanleitung

5.

Setting up

5.1 Switching on
beyerdynamic
MCS 100 V.1 - Software Version (E)
Reset N.o.m.
System check please wait
Reset N.o.m.
System O.K.
Reset N.o.m.
Level
Override NOM 0
Reset N.o.m.
Wrong number of
microphone units
Reset N.o.m.
5.2 Adjusting the user specific parameters
Important:
As the MCS system is delivered with manufacturer specific parameteres, all user specific parameters have to be adjusted at
the initial setting up.
User setup
loaded
Reset N.o.m.

5.3 Configuration

You access the configuration menu when you press both buttons simultaneously of the switched on MCS 100. The arrows in the
display indicate which buttons of the device have to be pressed, left (Reset) = M, right (N.o.m.) = L. To exit the individual menu items
press both buttons simultaneously. You will access the main menu again or return to the operation mode. The entered data is stored
automatically.
1. Parameter
Number of mics
More
Reset N.o.m.
When the system is switched on it carries out a system check checking all stored parameters.
An error message appears at a deviation.
System O.K. = the conference system is ready for operation
After the system check the default screen appears indicating the adjusted mode (Autonomy,
Override, Request-to-talk, Automatic), the signal level of the connected devices/microphone units
and the actual number of switched on microphones, including chairman microphone units.
If this error message occurs, carry out a configuration (refer to chapter 5.3 "Configuration" or
adjust the user specific parameters and configurate the corresponding parameters (refer to chapter "5.2
Adjusting the user specific parameters").
To adjust the user specific parameters you have to press the right (5) and left (4) button simulta-
neously when switching on the MCS 100.
The user specific adjustments must be changed in the configuration menu as described in the follo-
wing. When all parameters of the user specific adjustments have been changed and you exit the
menu, the parameters are stored and the system will re-start.
In this menu the number of connected microphones can be adjusted. Press the left button (4) to
enter the sub-menu.
43