Herunterladen Inhalt Inhalt Diese Seite drucken

Setting Up; Where To Place The Control Unit - Beyerdynamic MCW-D 50 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für MCW-D 50:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Power LED. LED is illuminated green when the unit is switched on.
1
Standby button. When this button is pressed for more than 3 seconds all switched-on microphone units are switched off.
2
When this button is pressed shortly all allocated microphones are switched off.
Reset. This button resets the system into the switch-on state (to press the reset button use a paper clip).
3
LEDs to indicate the status of the receiving channels. LED is illuminated green: the channel is vacant.
4
LED is illuminated red: the channel is occupied.
Volume control for the loudspeakers of the microphone units
5
Rear
RS 232 port for the connection of PC or media control system (9-pin Sub-D)
6
LAN network connection for PC
7
Control LED for antenna powering 5 V DC (green = normal DC ; flashing red rapidly = short circuit)
8
Switch -10 dB / +15 dB for unbalanced input (RCA)
9
Input, RCA, unbalanced, for the connection of external devices such as CD players (L + R)
10
Output - master output, RCA, unbalanced, for the connection of external devices such as mixing consoles,
11
sound contracting systems or recorders (L + R)
Level control for Output - master output, RCA
12
Switch -10 dB / +15 dB for balanced input (XLR)
13
Input, 3-pin XLR female, balanced, for the connection of external sound sources (+6 dBm)
14
Output - master output, 3-pin XLR male, balanced, for the connection of external devices such as mixing consoles,
15
or sound contracting systems
ON/OFF-switch
16
Fuse
17
Mains supply
18
Connection for receiving antennae
19
Connection for transmitting antenna
20

3.2 Setting up

3.2.1

Where to place the Control Unit

• If you do not use remote antennae*, place the MCW-D 50 control unit in the room where the meeting takes place. If you use
remote antennae*, place them in the conference room.
• Do not place the MCW-D 50 control unit near digitally controlled equipment.
*Important note for the USA and Japan: At present only the use of the CA 2413 remote antennae is permitted.
Downloaded from
www.Manualslib.com
19
10
6
7
8
9
manuals search engine
20
11
12
13
14
15
10
11
14
MCW-D 50 Control Unit
19
16
17
18
E
31

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis