Basic Functions - Trevi XF 4100 PRO Gebrauchs- Und Anschlusshandbuch

ENGLISH
Installing the Batteries
Remove the battery cover from the Remote Control and put 2xAAA size batteries inside the compartment. The diagram inside the
Battery Compartment shows the correct way to install the batteries.
TRANSPORTATION
For transportation, use the upper handle, slightly fold the appliance and use the two rear wheels.

BASIC FUNCTIONS

POWER ON/OFF
- Set the POWER ON/OFF switch (27) to "BAT" to Switch On and use the device with its internal battery.
- Set the POWER ON/OFF switch (27) to "OFF" to completely Switch Off the device.
- Set the POWER ON/OFF switch (27) to "AC" to Switch On and use the device with 230V
BATTERY CHARGE
- Set the POWER ON/OFF switch (27) to "OFF" to recharge the battery; the Battery status LED indicators will light.
For a longer battery life it is recommended to disconnect the mains power cable after 18 hours max of recharging.
States of the signaling LED indicator light Battery charging:
- LED BLUE: the device is connected with the adaptor and battery is being charged.
- LED GREEN: Charging finished, the battery is charged.
- LED RED: Battery is low.
MODE SETTING FUNCTION
To change the mode function, press more times the MODE button (9) on the unit or press MODE button (52) on remote control to
select: BLUETOOTH (the display BLUE), USB/SD (only if the USB socket (2)/Micro SD (3) is connected to a memory, the display
shows for a few seconds "USB" or "SD"), AUX-IN (the display shows "LINE").
ADJUSTING THE VOLUME
1. Turn the Main Volume control (23) to increase or decrease the overall volume of playback, or use the buttons (37) and (46)
on remote control;
2. Press the MIC button (6) and turn the knob (23) to adjust the volume of the signal on the MIC1 and MIC2 inputs, or press the
buttons (36) and (45) on the remote control. The regulation acts on the two inputs simultaneously.
PRE-EQUALIZER
This unit has a pre-set audio equalization system. Press the EQ button (11) on the unit or the EQ button (50) on the remote control
repeatedly to select one of the 5 audio equalizations available and which best suits the current sound reproduction.
SETTING TONE TREBLE AND BASS
Press the TREBLE button (4) and turn the knob (23) to adjust the treble, or press buttons TREBLE-/TREBLE+ (48) on remote control.
Press the BASS button (5) and turn the knob (23) to adjust the bass, or press buttons BASS-/BASS+ (38) on remote control.
MIC ECHO EFFECT
Press the MIC button (6) twice and turn the knob (23) to increase or decrease the echo effect on the microphone, or press buttons
ECHO-/ECHO+(33) on remote control
Note: the echo only works on microphone inputs.
13
XF 4100 PRO
50Hz power cable.