Basic Functions - Trevi XF 4200 DJ Gebrauchs- Und Anschlusshandbuch

ENGLISH
TRANSPORTATION
For transportation use the two side handles placed the device or the two top handles, slightly bend the device and exploit the two
rear wheels.
POWER
This unit works with power supply 230V
To activate the unit, insert the power cord into the socket on the device (31) and plug into a power outlet.
Do not connect the appliance to electrical outlets other than those indicated.

BASIC FUNCTIONS

POWER ON
1. Set the main POWER ON/OFF switch (28) to the "ON" position;
2. Wait for 5 seconds until the message appears on the display;
3. Press the button (18) on the unit, the center console will light up.
POWER OFF/STAND-BY
1. It is possible to bring the appliance into Stand-by mode by using the button
control;
2. Set the main POWER ON/OFF switch (28) to the "OFF" position to completely switch off the appliance.
Caution:
- There is no LED that signals the activation of the Stand-by function, only the display shows a scrolling text.
SELECTION OF THE FUNCTION ON CHANNEL A AND CHANNEL B
A CHANNEL
For channel A, the following functions are available: BLUETOOTH, USB, AUX-IN.
1. Move the balance control (8) on the unit to the left (Channel A);
2. To change the operating mode, press the M button (7) on the unit several times or press the corresponding function button (36)
on the remote control.
B CHANNEL
For channel B the following functions are available: USB, AUX-IN.
1. Move the balance control (8) on the unit to the right (Channel B);
2. To change the operating mode, press the M key(10) on the unit several times or press the corresponding function key(48) on
the remote control.
VOLUME CONTROL
1. Turn the VOLUME knob(15) on the unit to increase or decrease the general playback volume or use the buttons (47) on the
remote control.
2. Turn the MIC VOL knob(22) to adjust the volume of the signal on the MIC1(23), MIC2(21) inputs of the microphones.
PRESET EQ AND ADJUST EQUALIZER SETTING
This unit has a pre-set audio equalization system. Press the EQ button (25) on the unit repeatedly or the button (45) on the remote
control to select one of the 5 audio equalizers available and which is best suited to the current sound reproduction.
Holding down the EQ button (25) on the unit for 2 seconds or the button (45) on the remote control will access the "personal equa-
lization" status; this allows you to increase/decrease the gain for specific frequency ranges and adjust the audio output according
to your preferences.
• Move the slider bars to adjust the equalizer settings for each of the 5 frequency ranges.
DISCO-LIGHT EFFECTS
To activate the Disco-Light effects on the speakers, press the LED button (13) on the unit or the button (34) on the remote control.
To deactivate the Disco-Light effect, press the LED button (13) on the unit or the button (34) on the remote control again.
APPLY DJ EFFECT MANUALLY
EFFECTI 1.
You can also add preset DJ effects by yourself in A channel.
50Hz.
15
(18) on the unit or the button (33) on the remote
XF 4200 DJ