Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8.6.1 Selecting the channel on the remote control / synchronising the luminaire
Remote control
• Before using the remote control for the first time, insert sufficiently charged rechargeable
batteries or compatible batteries (2x AAA 1.5 V) into the remote control.
• Switch the light on at the ON / OFF switch (5) (if not already done). The remote control does
not work if the main switch on the fixture is turned off.
• Press the ON / OFF switch on the remote control once briefly to activate the display.
• Activate the channel selection, NO LED lights up in the display of the remote control.
• If the channel selection is not set, press the <menu selection> button on the remote control
repeatedly until NO status LED lights up in the display of the remote control. Each time you
press the <function selection> button on the remote control, you switch between setting the
brightness, the colour temperature (Bi Color model only) and the channel.
• Check the currently selected settings on the display of the unit and the remote control.
The selected channel on the remote control must match the channel set on the unit.
• The currently set channel of the remote control is shown in the display of the remote control
• Set the desired channel of the remote control by pressing the plus <+> or minus <-> button on
the remote control.
• Channels from 1 to 99 can be set.
• Press the <menu selection> key again to confirm the channel selection and return to the
brightness adjustment setting menu (basic setting).
• Finally, check whether the data set on the remote control and on the unit match. If necessary,
correct the values on the fixture as described in section 8.4.
• The luminaire is now ready to be controlled by remote control.
• The display of the remote control has an automatic switch-off. To reactivate the display,
briefly press the <ON / OFF> button.
8.6.2 Switching the unit on / off / standby status by remote control
• Switch the light on at the ON / OFF switch (5) (if not already done). The remote control does
not work if the main switch on the fixture is turned off.
• Press the ON / OFF switch of the remote control once briefly to activate the remote control.
• Make sure that the unit and the remote control are correctly connected and set to the same
channels (see previous section 8.6.1)
• By pressing the <ON / OFF> button on the remote control for a longer time (approx. 2 - 3 seconds),
you can switch off the fixture and put it into standby mode.
• By briefly pressing the <ON / OFF> button on the remote control, you can switch the light on
again with the remote control in standby mode.
• The remote control has an automatic switch-off function. To reactivate the display, briefly
press the <ON / OFF> button.
34
Werbung
Inhaltsverzeichnis
