Safety; Intended Use Of The Machine; Technical Restrictions; Prohibited Use / Hazardous Misapplications - Zipper Maschinen ZI-GPS252 Betriebsanleitung

11

SAFETY

This section contains information and important notes on the safe commissioning and handling of the ma-
chine.
For your safety, read this manual carefully before commissioning. This will enable you to handle
the machine safely and thus prevent misunderstandings as well as personal injury and dam-
age to property. Pay special attention to the symbols and pictograms used on the machine as
well as the safety information and danger warnings!
11.1

Intended use of the machine

The machine is intended exclusively for the following activities:
- As a trimmer for trimming and cutting lawn, grass, scrub, weeds and weak woody vegetation.
- As a hedge trimmer for cutting branches and fresh shoots on hedges and bushes.
- As a pole pruner: for cutting off branches on standing trees
in each case within the specified technical limits.
ZIPPER MASCHINEN GmbH assumes no responsibility or warranty for any other use or use
beyond this and for any resulting damage to property or injury.
11.1.1

Technical Restrictions

The machine is intended for use under the following ambient conditions:
Relative humidity:
Temperature (for operation):
Temperature (Storage, Transport):
11.1.2

Prohibited Use / Hazardous misapplications

• Operating the machine without adequate physical and mental fitness.
• Operating the machine without knowledge of the manual.
• Modifying the machine design.
Operating the machine outside the technical limits specified in this manual.
•
Removing of the safety markings attached to the machine.
•
Modifying, circumventing or disabling the safety devices of the machine.
•
The non-intended use or the disregard of the explanations and instructions described in this manual will
result in the expiration of all warranty claims and compensation claims for damages against ZIPPER
MASCHINEN GmbH.
11.2

User Requirements

The machine is designed to be operated by one person. The prerequisites for operating the machine are
physical and mental fitness as well as knowledge and understanding of the operating instructions. Persons
who, due to their physical, sensory or mental capabilities, inexperience or lack of knowledge, are unable to
operate the machine safely must not use the machine without supervision or instruction by a responsible
person.
Please note that locally applicable laws and regulations determine the minimum age of the operator and
may restrict the use of this machine!
Work on electrical components or equipment may only be carried out by a qualified electrician or under the
guidance and supervision of a qualified electrician.
Put on your personal protective equipment before working on the machine.
11.3

General safety instructions

To avoid malfunctions, damage and health impairments when working with the machine, the following
points must be observed in addition to the general rules for safe working:
Check the machine for completeness and function before starting. Only use the machine if the
•
separating and other non-separating protective devices required for machining have are fitted.
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
N O TE
max. 90 %
+5° C bis +40° C
-20° C bis +50° C
SAFETY
26
ZI-GPS252