Colour Automatic Mechanism- Time Programming; Programming Colour Interval Time - Sentiotec Wave.com4 Montageanleitung

Instructions for assembly and use
After a programmable time the control unit automatically changes to the next highest colour.
The keys allow the colour to be relayed manually.
When the keys are pressed simultaneously, the colour transition period of the colour LED
module can be programmed (see colour LED module operating instructions).
You can access the programming for the automatic mechanism time via the button.
You can switch off completely with the key.

4.4.0 COLOUR AUTOMATIC MECHANISM- TIME PROGRAMMING

Switch on the control unit with the key. You can then access the "colour automatic
mechanism time programming" menu with the key.
The 7 segment display shows you the time remaining (in minutes) for the active colour until the
next change.
The interval time is shortened or lengthened on a one-time basis with the keys. The next
change then occurs again with the programmed standard interval time.
You can programme the standard interval time by simultaneously pressing the keys (see
Point 3.5.0 of these operating instructions).
The key takes you to manual operation (see Point 4.6.0 of these operating
instructions).
Pressing the key switches the device off.

4.5.0 PROGRAMMING COLOUR INTERVAL TIME

As soon as you switch the control unit on, the (ready for operation) and (Automatic
mechanism) symbols illuminate and the (time) symbol flashes.
The 7 segment display shows the programmed standard interval time (in minutes).
WE DO IT FIRST.
38 /228