Sentiotec Wave.com4 Montageanleitung Seite 64

Instructions for assembly and use
The operation time of the sauna control unit can be set. An acoustic signal sounds when the set
operation time expires.
The Wave.com4 sauna control unit starts every operation with the last used parameters:
•
set temperature
•
operation time
•
brightness (cabin light) The last desired temperature settings,
The following table indicates which devices you require for which operating mode.
Function
Device
WC4-B-L +
WC4-B-x**
WC4-B-L +
WC4-B-x** +
WC4-H-PCB +
WC4-H-F2
WC4-B-L +
WC4-B-x** +
WC4-H-PCB +
WC4-H-H
WC4-B-L +
WC4-B-x** +
WC4-H-PCB +
WC4-H-F2+
WC4-H-H
WC4-B-TCH+
WC4-B-L (> V17.3)+
WC4-H-PCB +
WC4-H-F2+
D-sensor
WC4-B-TCH+
WC4-B-L (> V17.3) +
WC4-H-PCB +
WC4-H-H
WC4-B-TCH+
WC4-B-L (> V.17.3) +
WC4-H-PCB +
WC4-H-F2+
WC4-H-H
*If precise temperature measurement and the display of the cabin temperature are
required, the necessary components are optionally available.
WE DO IT FIRST.
Finnish
mode
Yes
Yes*
Yes
Yes*
Yes
Yes
Yes
Humidity/combi
mode
No
Yes- timed humidity
mode
Yes
Yes*
Yes- timed humidity
mode
Yes
Yes
11 /228