Preparing Worktop - hanseatic 65C90C7-E11B200 + MC-IF7136B2-AC Gebrauchsanleitung

Page EN-34 Installation

Preparing worktop

The following conditions must be fulfilled:
– The worktop must be at least 38-48 mm
thick and at least 600 mm deep. It must
also be horizontal and level, and it must be
sealed on the wall side against overflowing
liquids.
– The hob must be surrounded by at least
50 mm of worktop on all sides.
– Veneers, plastic coverings and adhesives
which are used must be resistant to heat
(100 °C).
1. Use a jigsaw to cut a hole in the worktop
for the hob. It must have the following di-
mensions.
560 to 564
(Measurements in mm)
2. If a hob was already installed, the cut-out
section must be no larger than:
560 to max. 574 mm wide
490 to max. 492 mm deep.
574
Attach rails!
7 560
(Measurements in mm)
3. Attach adjustment strips to the left and to
the right of the worktop in order to achieve
the width of 560 mm.
4. Seal the cut surfaces with a special var-
nish, silicone sealant or cast resin to pre-
vent swelling caused by moisture.
7