Dräger X-node Technisches Handbuch Seite 48

en |
Device installation and commissioning
3. Press in the sensor until the rubber ring lies flush on the housing
of the X-node.
 The X-node starts (status LED flashes blue, red, green).
48
4. Secure the sensor by screwing on the bayonet ring.
After inserting the sensor, the X-node will start and the gas
measurement begins. If a LoRa connection has been configured
and activated, the X-node will start sending the data, see
5.6.3 Setting up/adjusting the LoRa connection.
Technical manual |
Dräger X-node