Device Installation And Commissioning; Device Installation - Dräger X-node Technisches Handbuch

en |

Device installation and commissioning

Sensor designation
DrägerSensor MEC NO
DrägerSensor MEC O
2
4 Device installation and commissioning
4.1

Device installation

There are two ways to install the X-node:
– Suspended:
When suspending the device, a carabiner or loop is guided
through the suspension device and the device is then suspended
on a chain or rope.
Please take care that the device does not swing or oscillate,
and at no time should it tilt to the side by more than 30°.
46
Part number
6812785
6812740
– Standing:
Alternatively, the device can be placed on the bayonet ring.
If the X-node is placed on the bayonet ring, the openings must be
kept free at all times to ensure there is a circulation of gas.
Access to the sensor must be kept free of any obstacles to
ensure the gas reaches the sensor.
Technical manual |
Dräger X-node