Waeco mobitronic RV-400SC Montage- Und Bedienungsanleitung Seite 41

Collected_RV-400SC_rev2_Q4
The camera cable must be installed in such a way that you can easily reach the plug
connection between camera and connection cable when possibly removing the camera.
The disassembly is thereby substantially simplified.
The safest type of attachment is provided through screws being put through the con-
struction, whereby
some points are to be considered:
1. Is there enough free space for the assembly behind the selected position?
2. Each breakthrough must be protected by appropriate measures against an inrush of
underground water (e.g. by inserting the screws with sealing compound and/or was-
hing off the external mounting brackets with sealing compound).
3. Does the construction at the attachment place offer sufficient firmness so that the
camera holder can be tightened firmly enough?
If you are not quite sure about the assembly place selected by you, inquire with the con-
struction's manufacturer or its agency.
◆ Hold the camera holder at the selected assembly place and mark at least 2 different
drilling points (see H 1).
When fastening with sheet-metal screws
The fastening with sheet metal screws may only be made on sheet steel with a
minimum thickness of 1.5 mm.
The following is to be considered when executing drill holes in the metal plate:
– Check before whether sufficient free space for the drill outlet is present.
– In order to prevent a running of the drill, prick punch with hammer and prick punch.
– Debur all drill holes and provide with rust protection.
Drill a hole of Ø 4 mm at the points drawn beforehand.
Stick the double-sided adhesive insulating plate onto the assembly side of the
holder. This pad serves as gasket and lacquer protection (see H 1 and H 2).
Screw on camera holder with the metal screws 5 x 20 mm (see H 2).
Necessary parts for the attachment with sheet-metal screws see H 3 – H 4.
When attaching thread screws
The following is to be considered when executing drill holes:
– Check before whether sufficient free space for the drill outlet is present.
– Pay attention that the nuts when tightening, cannot pull themselves through the con-
struction (use possibly larger washers or sheet-metal plates).
19/06/03 9:56
Assembly of the outside camera
41
Page 41