The Handle (Winecase 6); The Handle (Winecase 8); Shelves; To Remove A Shelf - CASO DESIGN WineCase 6 Original Bedienungsanleitung

 For energy saving reasons please ensure that the door is closed when the appliance is
turned on.

13.5.2 The handle (WineCase 6)

The handle for opening the door is recessed on the upper side of the door.
13.5.1

The handle (WineCase 8)

The handle for opening the door is recessed on the left side of the door.

13.5.2 Shelves

Remove all bottles from the shelves. Lift the shelf upwards and the gently pull it out. Any of
the shelves can be removed to accommodate larger bottles.

13.5.3 To remove a shelf

Remove all bottles from the shelves. Lift the shelf upwards and the gently pull it out.
► Ensure that the tabs are firmly engaged in place before storing any bottles.
► Any of the shelves can be removed to accommodate larger bottles.
► Spread your bottles out as evenly as possible over the shelves, so weight is not
concentrated in one point; and make sure your bottles will not touch the back of the
cabinet.

13.6 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following
instructions must be observed for the electrical connection:
 Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device. If in doubt, ask your qualified electrician.
 The electrical outlet must be protected by a 16A safety cut-out switch.
 The connection between the device and the electrical network may employ a 3 meter
long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs
or gangs is prohibited because of the danger of fire that is involved with this.
 Make sure that the power cable is undamaged and has not been installed under or over
hot or sharp surfaces.
 This unit is not designed to be installed in an RV or used with an inverter.
 The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. Operations using an electrical outlet
without a protective conductor are prohibited. If in doubt, have the house installation
checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that are caused by a
missing or damaged protective conductor.
Please note
26