The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they guarantee
the prerequisites for the safe use of this device.
For energy saving reasons please ensure that the door is closed when the device is
turned on.
12.5.2
Feet
You can adjust the height of the device with the adjustable feet:
► You can reach the maximum height of the device of 875 mm by unscrewing the
adjustable feet as far as possible. Secure the nuts with an open-end wrench.
► For the minimum height of the device of 820 mm, remove the nuts from the adjustable
feet and screw them in completely.
1. Measure the height of the niche in which the device is to be placed.
2. Tilt the device forward slightly. Adjust the height of the device with the rear adjustable feet.
3. Tilt the device back slightly. Adjust the height of the device with the front adjustable feet.
4. Place the device at the installation site without any lateral pressure.
5. Tilt the device back slightly and then use the front feet to adjust the device.
12.5.3
The installation of the handle
The wine cooler comes with one metal stainless steel handle. To install simply screw them to
the door with the supplied screws.
To do this, slide the rubber seal on the back of the door to the side to lay open the predrilled
holes. Use the included screws to install the
handle on the door.
Then reinsert the rubber seal in the correct
position.
Please note
32