Herunterladen Inhalt Inhalt Diese Seite drucken

Manual Controls - Faber e-SliM Linear Fire Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Manual Controls

Standby
Heat
Heat Disable
Increase
Temperature
Decrease
Temperature
Temperature
Display
(°C °F)
Flame
Intensity
Extractor
Fan Boost
Ambient
& Flame
Theme
Brightness
Press
to turn on the unit or to put it in standby mode. There is a brief
delay after pressing
When the unit is turned on, there is a 3-minute warm-up sequence before
the flame effect starts.
Press
to turn the heat on or off.
When the heat is turned on, the display briefly indicates the set tempera-
ture (##ST), followed by the ambient room temperature.
When the heat is turned off, the fan continues to operate for a further 30
seconds to dissipate residual heat.
Press and hold
and
enable the heat function. This action must be performed on the hidden
touch controls.
When the heat is disabled and
play.
Press
to increase the temperature setting.
The temperature can be set from 15° C to 30° C (59° F to 86° F).
Press
to decrease the temperature setting.
Press and hold
and
displayed temperature unit. This action must be performed on the hidden
touch controls.
Press
repeatedly to adjust the flame intensity setting. The display indi-
cates LOW, MED (medium), or HIGH.
NOTE: Allow 15 minutes of operation before adjusting the flame inten-
!
sity.
The extractor fan boost clears any excess fogging that may appear in the
fireplace.
Press and hold
for 5 seconds to turn on the extractor fan boost. Once
finished, the flame will resume on the low setting. This action must be
performed on the hidden touch controls.
Press
repeatedly to cycle the 8 different Ambient & flame color
themes:
1 - Natural Flame
2 - Blue
3 - Violet
4 - Red
5 - Aquamarine
6 - Prism Mode - media and overhead lights cycle through colors
7 - Kaleidoscope Mode - media and overhead lights cycle through colors
at different rates.
8 - Custom (app required)
Press
repeatedly to cycle the top light brightness settings:
B1 - Brightness level 1
B2 - Brightness level 2
B3 - Brightness level 3
B4 - Brightness level 4
B5 - Brightness level 5
B6 - Pulsating effect
before the unit turns on.
at the same time for 3 seconds to disable or
is pressed, CD52 appears on the dis-
at the same time for 3 seconds to change the
25

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Olf46-euOlf66-euOlf86-eu

Inhaltsverzeichnis