Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
32
DI...
Fig. 5.2
One or more signals will then be displayed on the graph, depending on the
strength of the signal and the interrogator settings. Activate "Autoscale" if the
signal is not initially visible. If the signal is still not visible after this, check the
optical sensor connection on the device. Also check that you have selected the
right connection (CH1, CH2, etc.), in the dialog box.
NOTE
If you have connected a screen to the interrogator, you can also check the
display at "DUT". This is where the available connections, CH1 to CH4 and a
multiplexer, if connected, are displayed, as well as the sensors that have been
located for each connection. If there is a 0 for a relevant connection, the
interrogator has not detected any sensors.
HBM
A2301-1.2 en/de
Werbung
Inhaltsverzeichnis
