Assembly; Operation - Husqvarna 240i Bedienungsanweisung

bar, the saw chain can derail. An incorrect saw chain
tension increases wear on the guide bar, saw chain
and chain drive sprocket. Refer to
page 41 .
(Fig. 48)
To assemble the guide bar and saw
chain (with bar knob)
WARNING:
before you assemble or do maintenance on
the product.
1. Disengage the chain brake. (Fig. 50)
2. Loosen the knob and remove the drive sprocket
cover and the transportation guard (A). (Fig. 51)
3. Put the guide bar on top of the bar bolt. Steer the
guide bar to its most rear position. Lift the saw chain
above the drive sprocket and engage it in the groove
on the guide bar. Start on the top edge of the guide
bar.
4. Make sure that the edges of the cutters point forward
on the top edge of the guide bar. (Fig. 52)
5. Install the drive sprocket cover and steer the chain
adjuster pin to the hole in the guide bar.
6. Make sure that the drive links of the saw chain fit
correctly on the drive sprocket.
7. Make sure that the saw chain is correctly engaged in
the groove in the guide bar.
8. Apply tension to the saw chain. Refer to
Maintenance on page 34 for instructions.
9. Tighten the bar knob.
To assemble the guide bar and saw
chain (with bar bolt)
WARNING:
before you assemble or do maintenance on
the product.
Introduction
WARNING:
safety chapter before you use the product.
28
Accessories on

Assembly

Always remove the battery
Always remove the battery

Operation

Read and understand the
• Do maintenance on the cutting equipment regularly
and keep it correctly lubricated. If the saw chain is
not correctly lubricated, the risk of wear on the guide
bar, saw chain and chain drive sprocket increases.
(Fig. 49)
1. Disengage the chain brake. (Fig. 50)
2. Loosen the bar nut and remove the drive sprocket
cover. (Fig. 53)
3. Put the guide bar on top of the bar bolt. Steer the
guide bar to its most rear position. Lift the saw chain
above the drive sprocket and engage it in the groove
on the guide bar. Start on the top edge of the guide
bar.
4. Make sure that the edges of the cutters point forward
on the top edge of the guide bar. (Fig. 52)
5. Install the drive sprocket cover and steer the chain
adjuster pin to the hole in the guide bar.
6. Make sure that the drive links of the saw chain fit
correctly on the drive sprocket.
7. Make sure that the saw chain is correctly engaged in
the groove in the guide bar.
8. Tighten the bar nut with your fingers.
9. Tighten the saw chain. Refer to
page 34 for instructions.
To install the battery charger on the
wall
CAUTION:
Do not use an electric
screwdriver to install the battery charger to
the wall. An electric screwdriver can cause
damage to the battery charger.
1. Install the battery charger on the wall with the 2
screws (B). Use wall plugs (A) if it is necessary. (Fig.
54)
2. Install the 2 screw hole plugs (C).
3. Connect the power cord to the battery charger and a
mains socket.
To do a function check before you use
the product
1. Do a check of the chain brake (A) to make sure that
it operates correctly and that it is not damaged.
2. Do a check of the rear right hand guard (B) to make
sure that it is not damaged.
3. Do a check of the power trigger and the power
trigger lockout (C) to make sure that they operate
correctly and that they are not damaged.
Maintenance on
1951 - 001 - 23.09.2022