Mma Welding - Parkside PMSG 200 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Z
Overlap welds
The most common preparation is that
with the straight weld edges. The weld
can be released using a standard angle
weld seam. Both workpieces must be
brought as close to each other as possi-
ble, as shown in Fig. AB.
AB
 MMA welding
Make sure that the main switch

is set to position "O" ("OFF") or that
the power plug
into the socket.
Connect the electrode holder

the earth terminal
device, as shown in Fig. AC). Also
refer to the information from the
electrode manufacturer.
Put on appropriate protective cloth-

ing in accordance with the specifi ca-
tions and prepare your workspace.
Connect the earth terminal

workpiece.
Clamp the electrode into the elec-

trode holder
34
5
is not plugged
3
and
34
to the welding
4
to the
4
.
Using the device / MMA welding
Switch the device on by setting the

main switch to the
position.
Select "MMA" mode by pressing the

selector switch for welding mode
until the small indicator lamp next to
MMA lights up.
Adjust the welding current using the

rotary switch for welding current
adjustment depending on the
6
electrode you are using.
AC
Note: Guideline values for the welding
current to be used, depending on the
electrode diameter can be taken from
the following table.
Ø Electrode
1.6 mm
2.0 mm
2.5 mm
3.2 mm
Note: By pressing the voltage reducer
selector key you can activate the
37
voltage reducer function (VRD). The LED
next to "A/VRD" lights up. By doing this
the output voltage is reduced and the
safety for the user during breaks from
welding will be increased.
"I" ("ON")
5
35
36
35
6
34
4
Welding current
40–55 A
55–65 A
65–80 A
80–120 A
GB/CY 25
,