Cleaning; Maintenance - eder ESG-C 400200 Bedienungsanleitung

> Replace the circular knives (2 - Fig. 16) or turn them by 180°.
> Retighten the knife screws. Tightening torque: 35 Nm.

Cleaning

To work safely, you must clean the device after each use. In case of
heavy use, also during work if necessary.
> Remove all wood debris, chips and other dirt.
> Use a brush to clean the attachments.
> Be sure to keep the air slots on your drive motor clear. While

Maintenance

409001_03 | 10.2022
Danger during maintenance, repair and cleaning work with the
drive motor running!
Before carrying out maintenance, repair and cleaning work,
switch off the drive motor and secure the device against being
switched on again.
working, accessories can become slightly sticky due to the
presence of resin and chips.
Danger during maintenance, repair and cleaning work with the
drive motor running!
Before carrying out maintenance, repair and cleaning work,
switch off the drive motor and secure the device against being
switched on again.
Danger from changes to the device!
> Only carry out the maintenance and repair work described in
this manual.
> Do not make any changes to the device.
WARNING
WARNING
Attachments with chain drive
EN
76