eder ESG-C 400200 Bedienungsanleitung Seite 63

Fig. 3: Putting on the chain
> Fit the protective plate to the guide bar (1 – Fig. 4).
3
2
1
Fig. 4.: Mounting the protective plate
> The groove cutter and the carving cutter has another protective
plate (2 -Fig.4). This is screwed to the housing with two hexagonal
screws (3 - Fig.4).
ETH-C assembly
> Mount the trough cutter to the guide bar with the four hexagonal
bolts.
To mount the protective plate, first screw the two setscrews (1 - Fig.
5) into the guide bar so that approx. 5mm protrude on both sides. Then
63 Attachments with chain drive 409001_03 | 10.2022