Eder Wire Brush Erb-C; Eder Bark Beetle Cutter Ebf-C - eder ESG-C 400200 Bedienungsanleitung

EDER Wire Brush ERB-C

Changing the wire brush
Fig. 13: Changing the wire brush
> Unscrew the drive sprocket using the pin wrench.
> Unscrew the short bearing shaft and the long bearing shaft.
> Remove the wire brush from the housing and loosen the locking
> Using the wrench, unscrew the grooved locknuts. The wire brush
> When reassembling, make sure that the locknuts are firmly seated
> Remount the short and long bearing shafts and tighten them.
> Screw the drive sprocket back on and tighten it using the pin

EDER Bark Beetle Cutter EBF-C

Sharp knives are required for optimal work with the EDER Bark Beetle
Cutter EBF-C.
Replacing knives
> Unscrew the drive sprocket using the pin wrench.
> Unscrew the short bearing shaft and the long bearing shaft.
73 Attachments with chain drive
plate by bending back its bent lug so that the grooved locknut can
turn freely.
can then be pushed off the shaft.
(35Nm) and bend one lug of the locking plate back into the groove
of the locknut.
Tightening torque: 35 Nm
wrench.
Blunt knives can be sharpened manually using normal
i
grinding wheels.
409001_03 | 10.2022