Eder Carving Cutter Esf-C - eder ESG-C 400200 Bedienungsanleitung

> Remove the shaft from the housing and loosen the locking plate
> Using the wrench, loosen the grooved locknut. The knives can then
> When reassembling, make sure that the locknuts are firmly seated
> Remount the short and long bearing shafts and tighten them.
> Screw the drive sprocket back on
Fig. 14: Replacing knives

EDER Carving Cutter ESF-C

Sharp knives are required for optimal work with the EDER carving
cutter ESF-C.
For adjustment you need the supplied knife gauge.
Both knives are adjusted in the same way.
409001_03 | 10.2022
by bending back its bent lug so that the grooved locknut can turn
freely.
be pushed off the shaft.
(35Nm) and bend one lug of the locking plate back into the groove
of the locknut.
Tightening torque: 35 Nm
Blunt knives can be sharpened manually using normal
grinding wheels. Cutting edge angle is 40°. The rounding
i
radius of the knives must be maintained, otherwise the knives
will carve unevenly.
The knives must not protrude more than 1 mm beyond the
i
milling head, as the milling head serves as a depth limiter.
Attachments with chain drive
EN
74