Explanation Of Standard Symbols; Symbols In Graphics/Instructions - Wilo CronoLine-IL-E Einbau- Und Betriebsanleitung

English
8.3

Explanation of standard symbols

Symbol Description
Constant speed control
Constant control
Δp-c
Variable control
Δp-v
PID control
Input In2 (external setpoint)
2
activated
Access disable
BMS (Building Management System)
is active
DP/MP operating mode:
Parallel operation
Table 7: Standard symbols
8.4

Symbols in graphics/instructions

Menu elements
Actions
92
The following symbols are shown on the display at the positions
shown above:
Symbol
min
max
Chapter 8.6 "Operating instructions" on page 95 contains graphics
that illustrate the operating concept and provide instructions for con-
figuring settings.
In the graphics and instructions, the following symbols are used as
simple representations of menu elements or actions:
• Menu status page: Standard view on the display
12.3
• "One level down": A menu element that can be used to jump to a
4.1.0.0
lower menu level (e.g. <4.1.0.0> to <4.1.1.0>).
• "Information": A menu element that shows information about the
device status or settings that cannot be changed.
± • "Selection/setting": A menu element that provides access to a
4.4.3.0
2.0.0.0
changeable setting (element with menu number <X.X.X.0>).
"One level up": A menu element that can be used to jump to a higher
menu level (e.g. <4.1.0.0> to <4.0.0.0>).
Menu error page: In the event of an error, the current error number is
E000
displayed instead of the status page.
• Turn operating button: Turn the operating button or increase or
decrease settings or menu numbers.
• Press operating button: Press the operating button to activate a
menu element or confirm a change.
• Navigate: Perform the steps that follow to navigate in the menu to
the displayed menu number.
• Wait time: The remaining time (in seconds) is displayed on the value
display until the next state is reached automatically or manual input
can be made.
ON • Set DIP switch to the 'OFF' position: Set the DIP switch number "X"
under the housing cover to the 'OFF' position.
X
ON • Set DIP switch to the 'ON' position: Set the DIP switch number "X"
under the housing cover to the 'ON' position.
X
Description
Min operation
Max. operation
Pump is running
Pump stopped
Pump running in emergency operation
(icon flashes)
Pump stopped in emergency operation
(icon flashes)
DP/MP operating mode: Main/reserve
-
WILO SE 08/2022