Electrical Connection Of The P2Va1/A2 - HBM P2V A1 Montageanleitung

5

Electrical connection of the P2VA1/A2

An external amplifier is connected to the P2V in accordance with Fig. 5.1.
Notice
The inputs and outputs of the P2V are protected against short circuits and
reverse polarity.
Supply voltage 15 to 30 V DC
Supply voltage 0 V
Output 0.5 to 10 V (4 to 20 mA for the P2VA2)
Output 0 V
Transducer identification TEDS DATA
5
4
1
Fig. 5.1 Pin assignment of the P2V
CAUTION
Using the TEDS memory: Because of the electrical specifications, voltages > 6
V must never be applied to the TEDS memory. Never connect the supply volt­
age of the P2V with TEDS pin 5. This would destroy the memory.
If the P2V is connected with the HBM MGCplus amplifier system, the connec­
tion is made via AP01i, as shown in Fig. 5.2.
P2V
1)
2)
Connections 2 and 3 are internally linked.
3
1)
Operating on a SELV circuit (separated extra-low voltage)
2)
also ground for TEDS
2
A01564_07_Y00_01 HBM: public
Electrical connection of the P2VA1/A2
1
3
4
2
5
brown
blue
Connection
black
cable wire
white
assignments
gray
11