HBM P2V A1 Montageanleitung Seite 7

Symbol
Notice
Emphasis
See....
CE mark
Conversions and modifications
The P2V/xxx pressure transducer must not be modified from the design or
safety engineering point of view except with our express agreement. Any modi­
fication shall exclude all liability on our part for any damage resulting there
from.
Qualified personnel
The pressure transducer is only to be installed and used by qualified personnel
strictly in accordance with the technical data and with the safety rules and reg­
ulations which follow. It is also essential to observe the appropriate legal and
safety regulations for the application concerned during use. The same applies
to the use of accessories.
Qualified personnel means persons entrusted with the installation, assembly,
commissioning and operation of the product, who possess the appropriate
qualifications for their function.
Recalibration and repair
When you send the transducer back to HBM for calibration or repair, please
specify which pressure medium is being used. It is always possible that resid­
ual medium could be trapped in the measuring aperture. We need this inform­
ation so that we can take appropriate action and choose the correct cleaning
agent, where necessary. If we do not know the media, we may have to refuse
to calibrate or repair.
P2V
Significance
This marking draws your attention to a situation in
which failure to comply with safety requirements can
lead to damage to property.
Italics are used to emphasize and highlight text and
references to other chapters and external documents.
The CE mark enables the manufacturer to guarantee that
the product complies with the requirements of the rele­
vant EC directives (the EC Declaration of Conformity can
be found at http://www.hbm.com/HBMdoc).
A01564_07_Y00_01 HBM: public
Safety instructions
5