Taking The Unit Out Of Operation; Maintenance And Cleaning - Oase ProMax Garden Classic 3000 Gebrauchsanleitung

Taking the unit out of operation

How to proceed:
1. Switch off the pump
2. Disconnect the power plug.
3. Depressurise the pressure line by opening the water withdrawal points.
4. Also open any non-return valves fitted in the suction line.
– When the pump is switched off, residual water in the hose may flow back and out of the
pump intake.
If the pump is to be completely removed:
5. Remove the connected hoses on the pressure and suction side.
6. Undo the water drain screw and tip the pump to allow the residual water to drain out.
7. Screw in the water drain screw again.
– Check that the seal is in place and correctly functioning.

Maintenance and cleaning

NOTE
Do not use aggressive cleaning agents or chemical solutions. These agents can damage the
housing, impair the function of the device and harm animals, plants and the environment.
Clean only the outside of the unit with a damp cloth.

EN
POX0033
15