Cleaning The Blender; Storage; Troubleshooting; Technical Data - Silvercrest SKM 550 B1 Bedienungsanleitung

Cleaning the blender

WARNING! RISK OF INJURY!
► Do not handle the blender knife with your
bare hands.
Clean the blender 4 in warm water with a little
■
mild detergent. Afterwards, rinse all parts with
clean water so that no detergent residues remain.
In most cases, you an also achieve suffi ciently hygienic
cleaning directly after use in the following way:
1) Put some water containing a little detergent
into the fully assembled blender 4.
2) Place the lid onto the measuring jug slightly
off set and then turn it until the lid clicks into
place (Image I).
3) Switch on the blender 4 for a few seconds.
4) Pour out the washing water. Any residues can
be removed with a washing-up brush.
5) Afterwards, rinse out the blender 4 with
plenty of clean water, so that all detergent
residues are removed.
ATTENTION! DAMAGE TO PROPERTY!
The blender 4 is not suitable for cleaning in
►
a dishwasher. Cleaning it in a dishwasher will
cause irreparable damage to the blender 4.

Storage

■ Place the mains cable in the cable storage com-
partment i when storing the appliance.
■ Store the cleaned appliance in a clean, dust-free
and dry location.
SKM 550 B1
All manuals and user guides at all-guides.com

Troubleshooting

If the appliance suddenly stops working:
■
If the appliance does not switch itself on:
If the steps described above do not solve the problem,
then the appliance is defective. Arrange for it to be
repaired by a qualifi ed specialist technician or by
the Customer Service Department.

Technical data

Input voltage:
Power consumption:
Max. capacity
Mixing bowl:
Blender:
Protection class:
The appliance has overheated and triggered the
automatic safety cut-out.
–
Turn the rotary switch r to 0.
–
Remove the plug from the wall socket.
–
Allow the appliance to cool for 15 minutes.
–
If the appliance has not yet cooled off com-
pletely after 15 minutes, it will not start.
–
Wait a further 15 minutes and try switching
on again.
–
Check that the plug is correctly connected
to a wall socket.
–
Check to make sure the protective cover
for the drive hub for the blender 4 and for
the continuous shredder 7 and the mixing
bowl 6 are all positioned correctly and
clicked into place.
–
Check to see if the pivoting arm t is in the
required position (see section "Operating
positions").
220 - 240 V ~ /50 Hz
550 W
approx. 3.8 l
approx. 1 l
II /
GB
11