Basic Settings - Resol DeltaTherm HC mini Handbuch Für Den Fachhandwerker

Error 1: flow sensor defective
Error 2: the flow temperature is higher than the maximum flow temperature + 5 K for
over 5 min
Error 3: the flow temperature is higher than the holding temperature + rise value for over
30 min
Error 4: the flow temperature is higher than the set flow temperature + rise value for over
2 h
Error 5: the flow temperature is lower than the set flow temperature - rise value for over
a rise time period
The left button (⟲) can be used any time for changing to the status or main menu
of the controller in order to carry out adjustments.
When the screed drying function has been successfully completed, the heating cir-
cuit changes to its previously selected operating mode.
Screed drying is automatically deactivated. The chimney sweeper function is auto-
matically activated.
Note:
Make sure the heating circuit is supplied with heat from a heat source
(backup heating).
Note:
If a Micro SD card has been inserted into the slot, a screed protocol will
be generated.
Heating / Screed drying
Adjustment
Description
channel
Funct. Activation / Deactivation
TStart Start temperature
TMax Holding temperature
Rise Temperature increase per rise time
Rise time Duration for emperature increase
tBacking TMax holding time
34
9
In the Basic settings menu, all basic parameters for the controller can be adjust-
ed. Normally, these settings have been made during commissioning. They can be
subsequently changed in this menu.

Basic settings

Adjustment range / Factory
selection setting
Activated, Deactivated Deactivated
10 ... 30 °C 20 °C
20 ... 60 °C 30 °C
1 ... 10 K 2 K
1 ... 24 h 24 h
1 ... 20 d 5 d
Basic settings
Adjustment
Description
channel
Language Selection of the menu language Deutsch, English, Français, Español,
Auto DST Daylight savings time selection Yes, No
Date Adjustment of the current date 01.01.2001 ... 31.12.2099
Time Adjustment of the current time 00:00 ... 23:59
Temp. unit Temperature unit
Scheme Scheme selection
Reset back to factory setting
Factory
Adjustment range / selection
setting
Deutsch
Italiano, Nederlands, Türkçe,
České, Polski, Portugues, Hrvatski,
Română, Български, Русский, Suomi,
Svenska, Magyar
Yes
01.01.2014
-
°C, °F °C
1 ... 4, 202 ... 804 1
Yes, No No