Kongskilde RVS 5000H Betriebsanleitung Seite 8

Replacement of rubber blades, scrapers and seal-
ing segments
Always disconnect the power to the separator before
repair and maintenance. The safety switch must be
interrupted and locked so that the separator can not be
started by mistake. Also stop the corresponding blower.
The separator's top part can be raised by loosening
/ removing the pipe connections on both sides of the
separator and loosening the eye bolts (1). Thereafter
the upper part can be lifted by crane and wire or chain
in the lifting eyes (2), see illustration.
When the top part is fully lifted, remove the bolt (3) and
fit into the locking position on both sides, after which
the wire or chain can be released.
The rubber blades (1) can be replaced by loosening the
M8 bolts and removing the steel plates. Be aware that
the chamfer of the blades is positioned correctly in rela-
tion to the direction of rotation, see illustration. To assist
the replacement, the motor can be removed, and the
adaptor inserted (see section "Electrical installation"),
This drawing is strictly confidential, and may not be reproduced or presented to any third party, without our permission
whereby the rotor can be rotated manually.
Illustrations for RVS users manual
Illustrationer for RVS brugsanvisning
121102946
Revision no:
8
.
2
.
.
3
.
3
1
Should the sealing segments (2) also be replaced, do A
this before re-mounting the rubber blades by loosening
the countersunk screws. Make sure the nuts on the rear
are correctly seated in the segment before tightening
the countersunk screws, see illustration.
This drawing is strictly confidential, and may not be reproduced or presented to any third party, without our permission
Illustrations for RVS users manual
The separator's top part is closed in the reverse order.
Illustrationer for RVS brugsanvisning
121102946
Revision no:
This drawing is strictly confidential, and may not be reproduced or presented to any third party, without our permission
Illustrations for RVS users manual
Illustrationer for RVS brugsanvisning
121102946
Revision no:
1
2
DETAIL A (1 : 2)
3