Procedure After Accidents; About The Pressure Regulating Valve; Exchange Of Nozzles; Before Use - Parkside HG06876 Montage-, Bedienungs- Und Sicherheitshinweise

Procedure after accidents

In case of accidents, please keep calm and follow
below steps:
While carrying the sprayer, put down the
device immediately.
The right shoulder belt
quick-release mechanism. Unlocking the belt
hook can allow you to release the right
27
shoulder belt at once.
30
Then release the left shoulder belt and slide
the device smoothly on the floor or flat surface.
In case of intoxication via skin contract, please
rinse with water immediately and consult doc-
tor advice.
Always report the Emergency for medical
services when you feel not well.
About the pressure
regulating valve
The Pressure Regulating Valve
device to reduce spraying pulse, maintain the
constant pressure, ensure even spraying, minimize
environmental pollution and enhance the pest
control performance.
The Pressure Regulating Valve
opened at pressure of 1.4± 0.2 bar, and normally
closed at pressure of 1± 0.15 bar. When the pres-
sure inside the tank increases above open pres-
3
sure, the sprayer can start spraying by compressing
its spray trigger . When the pressure is lower
17
than the close pressure, the regulating valve
will shut off automatically and stop spraying. You
shall pressurize the pump
ceed spraying.
Note: Residual pressure still exists in the tank
due to the regulating valve
ing was finished. Loosen the union nut
the spray tube . Open the lid of container
20
move the spray tube toward into the opening of
tank , press the spray trigger
3
residual pressure above the opening of tank
10 GB/IE/NI
is designed with a
30
is an important
22
is normally
22
22
if you desire to pro-
10
3
, even though spray-
22
and remove
16
,
1
to release the
17
.
3

Exchange of Nozzles

Protect yourself from hazardous
substances during exchanging the nozzles by
wearing suitable personal protective equipment
(PPE) (eye protection, respiratory protection,
protective clothing, waterproof gloves and
boots).
CAUTION! Check safe function!
Lossen the nozzle ,
23 24
pressure regulating valve
Replace and fasten the nozzle
to the pressure regulating valve
26

Before use

Protect yourself with suitable
personal protective equipment (PPE) of wearing
eye protection, respiratory protection, appro-
priate protective clothing, water-proof gloves
and boots from hazardous substances.
CAUTION! Check that the device is function-
ing properly! Check the pressure sprayer be-
fore each use to ensure that it is free of visible
damage and is functioning safely. To do this,
carry out the following tests and inspections:
The hose or O-rings
13 36
any cracks or appear porous.
Check the container , the hose
3
carry belts for visible damage.
30
Check that the hose connections
pipe connection and
16 21
ing valve and nozzles
22
are fitted tightly.
Check that the lid of container
air chamber are closed tightly.
11
Trial spraying with clean water and a check
of tank, hose, shut-off and nozzle for possible
leakage are required prior to operation.
Check that the filter screen
spray tube handle are not blocked. Filter
19
screen and filter on spray tube handle
31
are for filtering the solid substance."
, or from the
25 26
.
22
, , or
23 24 25
.
22
, must not show
39
and the
13
and ,
12 14
, pressure regulat-
or
23 24 25 26
and lid of
1
and filter on
31
19