Inhaltsverzeichnis
Werbung
Page 10
SPRINT 05 SW
Guide for the installer
5.3.3. l
ine
Terminals "N & F". These terminals are for connecting the 230/115 V~ power supply line.
5.3.4. e
.
Arthing
Terminal "PE" This terminal is for connecting the unit earthing wire. Connect the network line earthing wire to the terminal with the
corresponding symbol.
This connection is absolutely required for correct operation of the unit.
The unit is designed to house a 5-pin radio-receiver module. To install, cut off electrical power and insert the module in the provided
connector CN4 (see Fig.1) on the unit.
In order not to damage, and therefore irreparably compromise its operation, the receiver must be connected in the direction
shown in Fig.2
Then follow the instructions supplied with the radio-receiver for memorising the remote control.
All the programmable functions of the board are set using dip-switch DP1 (see Fig.1). The different options are listed in the diagram below.
Manual logic
Automatic logic with a 15-second pause.
Automatic logic with a 20-second pause.
Automatic logic with a 40-second pause.
Condo function disabled
Condo function enabled. During the opening phase, it ignores any further OPEN pulses.
Opens, closes, opens, closes, ...
Opens, stops, closes, stops, opens, stops, ....
The connected safety switches are active only during the gate closing movement
The connected safety switches are active both during the gate closing and opening movement.
Gate operation without the encoder
Gate operation with the encoder
ELECTRONIC CLUTCH SENSITIVITY (active only with the encoder connected and activated)
High, more sensitive to the obstacle
Medium-high
Medium-low
Low, less sensitive to the obstacle
Use the dip-switches only after having cut off power. Otherwise unit operation can be compromised
6. INSERTING THE REMOTE CONTROL RECEIVER BOARD (Fig. 4)
7. SETTING THE OPERATING PARAMETERS
OPERATING LOGIC
CONDO FUNCTION
OPEN A INPUT OPERATION
PHOTOCELL OPERATION
ENCODER
Werbung
Inhaltsverzeichnis
