Alarm Clock - Kenwood CR-ST700SCD Bedienungsanleitung

16. Alarm clock

This radio has 2 individually adjustable alarm times. Press and hold the <ALARM> button on the
device, and select "Alarm 1" or "Alarm 2" to a make the settings. You can make the settings using
the <NAVIGATE> knob. Alternatively, you can also call up the alarm function from the main menu.
In standby mode, the saved alarm clocks of the <ALARM> button can be activated and deactivated
on the device. The following options are available for programming the alarm clock:
16.1 Activated:
Select here on which days the alarm should be activated. The following selection is available: Off/
Daily/Once/Weekends/Weekdays
Select "Off" to deactivate an activated alarm clock.
16.2 Time:
Set the hours first with the <UP> or <DOWN> buttons and then the minutes after pressing the
<OK>.
16.3 Date:
The menu is enabled only "Once" for the setting. Using the <UP> or <DOWN> button, set the date,
month and the year. Complete each entry with the <OK> button.
16.4 Mode:
Here you set the audio source with which you want to wake up. The following selection is available:
Buzzer / Internet radio / DAB / FM
16.5 Program:
The station with which to wake up is specified here. The station last listened to or the stations saved
in the favourites are available here. Does not apply to buzzer mode.
16.6 Volume:
Set the desired alarm volume here.
16.7 Save:
Once you have made all the settings, please press the <OK> button to save the settings.
An activated alarm clock is shown with an alarm symbol and the number of the active alarm clock at
the bottom left of the display. In standby mode you can also see the set alarm time.
16.8 Switching off the alarm clock after waking up
To switch off the alarm clock until the next alarm cycle, please press the <Standby> button on the
device or on the remote control "Alarm OFF" appears briefly on the display. If you only want to
interrupt the alarm function for a few minutes (snooze), you can use any other button. The alarm
delay is set by pressing a button in steps 5, 10, 15 and 30 minutes and can also be extended again
and again. After a short time, the radio automatically switches back to "Standby" and the time
remaining until waking up again is displayed next to the flashing alarm symbol.
Note: The saved wake-up times are retained in the event of a power failure.
21