Scan Settings; Audio Settings; Saving Fm Stations In Memory Locations; Bluetooth Audio - Kenwood CR-ST700SCD Bedienungsanleitung

12.2 Scan settings

You can use this function to determine whether only stations with a strong reception signal are taken
into account. To do this, press the <MENU>, button and select "Scan setting". In the following
menu "FM Station search" you can now answer the question "Strong stations only?" with "YES"
or "NO". The current setting is identified by "*".

12.3 Audio Settings

For stations with poor reception, a slight quality improvement can be achieved by switching to mono
reception. To do this, press the <MENU> button and select "Audio setting". In the following menu
"Poor FM reception" you can now answer the question "Listen in Mono only?" with "YES" or
"NO". The current setting is identified by "*".
12.4 Favourites (memory locations)
40 memory locations (favourites) are available for storing FM stations.
12.4.1 Storing FM stations with the remote control:
Memory locations 1 – 10 can be assigned using the number buttons on the remote control. To do
this, select the desired station and press a number key on the remote control until "Preset stored"
appears on the display. The memory locations can now be called up by pressing the remote control
briefly.

12.4.2 Saving FM stations in memory locations 11 - 40:

Select the desired station and hold down the <FAVORITE> button on the radio or <FAV> on the
remote control. Now select a memory location from the list of station memories and confirm the
selection with the <NAVIGATE> button on the radio. The "Preset stored" appears on the display.
You can easily call up the memory locations by briefly pressing the <FAVORITE> button on the radio
or <FAV> on the remote control. Use the <UP/DOWN> buttons or the <NAVIGATE> knob to select
a station and press <OK> to confirm.
Note: The memory locations cannot be deleted, but can only be overwritten with other stations.

13. BLUETOOTH audio

The BLUETOOTH function enables the wireless transmission of music files (audio streaming) to the
radio. Smartphones, tablets or similar devices can be paired. To do this, select the source "Bluetooth
Audio" in the main menu.
13.1 Pairing BLUETOOTH devices for the first time (pairing)
Make sure that the terminal device to be paired is switched on and BLUETOOTH is activated. Select
the source "Bluetooth Audio" in the main menu. After a short time the "Bluetooth availability"
appears on the Display. Now open the BLUETOOTH settings on the terminal device to be paired and
start searching for available BLUETOOTH devices there. Select "KENWOOD CR-ST700SCD" and start
the pairing process. After successful pairing, "Connected" appears on the display. Now the music
playback can be controlled via the terminal. To do this, use the music App of your choice.
Basic operation of play/pause and skip forward/backward is possible using the corresponding buttons
on the remote control.
Note: Some terminal devices require a PIN code when connecting, then enter "0000".
19