En Troubleshooting; Troubleshooting - CONSTRUCTA CC4P86660 Gebrauchs- Und Montageanleitung

en Troubleshooting
5. Insert the drip tray into the tank shaft and slide it in
fully.
17 Troubleshooting
You can rectify minor faults on your appliance yourself.
Read the troubleshooting information before contacting
after-sales service. This will avoid unnecessary costs.
WARNING ‒ Risk of injury!
Improper repairs are dangerous.
▶
Repairs to the appliance should only be carried out
by trained specialist staff.
▶
If the appliance is defective, call Customer Service.
17.1 Malfunctions
Fault
The appliance is not
working.
lights up in the
display and no set-
tings can be made
on the appliance.
The interior lighting is
not working.
12:00 flashes in the
display and the
symbol lights up.
80
Cause and troubleshooting
The mains plug of the power cord is not plugged in.
▶
Connect the appliance to the power supply.
The circuit breaker in the fuse box has tripped.
▶
Check the circuit breaker in the fuse box.
There has been a power cut.
▶
Check whether the lighting in your kitchen or other appliances are working.
Malfunction
1. Switch off the fuse in the fuse box.
2. Switch the fuse back on after approx. 10 seconds.
a If the fault was a one-off, the message disappears.
3. If the message appears again, call the after-sales service. Please specify the exact error
message when calling.
→ "Customer Service", Page 82
Door is not fully closed.
▶
Check whether food remains or foreign material are trapped in the door.
Childproof lock is activated.
▶
Press and hold until
The LED lamp is defective.
▶
If this fault recurs, call the after-sales service.
There has been a power cut.
▶
Reset the time.
→ "Setting the time", Page 75
6. Close the tank cover.
a The appliance is ready to use.
WARNING ‒ Risk of electric shock!
Incorrect repairs are dangerous.
▶
Repairs to the appliance should only be carried out
by trained specialist staff.
▶
Only use genuine spare parts when repairing the
appliance.
▶
If the power cord of this appliance is damaged, it
must be replaced by the manufacturer, the manufac-
turer's Customer Service or a similarly qualified per-
son in order to prevent any risk.
goes out.