Maintenance; Safety; Preparation; Restarting - Optimum Optiturn TU 2506VB Betriebsanleitung

5

Maintenance

In this chapter you will find important information about
Inspection

Maintenance

Repair

of the lathe.
ATTENTION!
Properly performed regular maintenance is an essential prerequisite for

operational safety,

failure-free operation,

long durability of the lathe and

the quality of the products which you manufacture.
Installations and equipment from other manufacturers must also be in good order and condition.
5.1

Safety

WARNING!
The consequences of incorrect maintenance and repair work may include:

extremely serious injuries to those working on the lathe and

damage to the lathe.
Only qualified personnel should carry out maintenance and repair work on the lathe.
Electrical systems and operating materials may only be installed, modified and repaired
by a trained electrician or supervised and under the control of a trained electrician and
must comply with electrotechnical regulations.
WARNING!
Do not climb onto or into the machine while working.
5.1.1

Preparation

WARNING!
Only work on the lathe when the power plug of the lathe has been disconnected.
Attach a warning label.
5.1.2

Restarting

Before restarting, run a safety check.

Electronics on page 96

Safety check on page 94
WARNING!
Before starting the lathe, you must check that there is no danger for persons and that
the lathe is not damaged.
5.1.3

Cleaning

CAUTION!
Use a chip hook for removal of chips and wear suitable protective gloves.
EN TU2506VB
150 Translation of original instruction
Maintenance
Version 1.0 - 2020-12-22