Cleaning And Sanitizing Instructions - Hoshizaki KM-470AJE-R452 Bedienungsanleitung

B. Cleaning and Sanitizing Instructions
The icemaker must be cleaned and sanitized at least once a year. More frequent cleaning
and sanitizing may be required in some water conditions.
• To prevent injury to individuals and damage to the icemaker, do not use ammonia
type cleaners.
• Carefully follow any instructions provided with the bottles of cleaning and sanitizing
solution.
• Always wear liquid-proof gloves and goggles to prevent the cleaning and sanitizing
solutions from coming into contact with skin or eyes.
• Do not leave the icemaker unattended when panels are off.
• To prevent damage to the water pump seal, do not leave the control switch in the
"WASH" position for extended periods when the water tank is empty.
• The cleaning valve is opened during cleaning and sanitizing to allow solution flow
to the inside of the evaporator. It should be closed for all icemaking operation. The
compressor will not operate unless this valve is completely closed.
• To close the cleaning valve, the valve handle should be at a right angle to the valve
body. To open the cleaning valve, the valve handle should be parallel to the valve
body.
CLOSED
Icemaking Operation
Preparation
1) Remove the front panel, then move the control switch to the "OFF" position.
After 3 minutes, move the control switch to the "ICE" position, then replace the front panel.
2) After 3 minutes, remove the front panel, then move the control switch to the "OFF" position.
3) Remove all ice from the ice storage bin. WARNING! If on a dispenser unit, turn off the
dispenser unit power supply after dispensing the ice.
WARNING
IMPORTANT
Cleaning and Sanitizing Operation
(allows solution flow to the inside of the evaporator)
16
OPEN
ENGLISH