Final Checklist - Hoshizaki KM-470AJE-R452 Bedienungsanleitung

ENGLISH
G. Final Checklist
CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews are securely
in place after installation. Make sure that none have fallen into the dispenser unit/ice
storage bin.
1) Is the icemaker level?
2) Is the icemaker in a site where the ambient temperature is within 7°C to 38°C and the water
temperature within 7°C to 32°C all year around?
3) For KM-470AJE-R452, is there at least 30cm clearance at rear, sides, and top of the
icemaker.
4) Have the shipping carton, tape, and packing material been removed from the appliance? Is
the cube guide in the correct position? Are the separators between the evaporator banks
properly attached to their holding clips?
5) Have all electrical and water connections been made? Do electrical and water connections
meet applicable national, state, and local code and regulation requirements?
6) Has the power supply voltage been checked or tested against the nameplate rating? Has a
proper ground been installed to the icemaker?
7) Are the water supply and drain lines sized as specified? Are the water supply line shut-off
valve(s) and drain valve(s) installed? Has the water supply pressure been checked to
ensure a minimum of 0.07MPa (0.7bar) and a maximum of 0.78MPa (7.8bar)?
8) Is the compressor snug on all mounting pads? Have the refrigerant lines been checked
to make sure they do not rub or touch other lines or surfaces? Have the fan blades been
checked to make sure they turn freely?
9) Are all components, fasteners, and thumbscrews securely in place?
10) Has the end user been given the instruction manual, and instructed on how to operate the
appliance and the importance of the recommended periodic maintenance?
11) Has the end user been given the contact information of an authorized service agent?
WARNING
13