Operation - Scheppach TBT19Vario Original Bedienungsanleitung

Installing the machine
Before you use the drill for the first time it must be mounted in a station-
ary position on a firm surface. Use both mounting holes in the base plate
to do this. Ensure that the machine is freely accessible for operation,
adjustment and maintenance.
Important: The fixing screws may only be tightened to a point where
they do not distort or deform the base plate. Excessive tension can lead
to fracture.
Prior to starting
Ensure that the voltage of the mains supply complies with the specifi-
cations on the rating plate. Connect the machine only to a socket with
the properly installed earthing contact. The table drill is equipped with
a no-volt trip that is designed to protect the operator from an undesired
restart following a drop in voltage. Should this occur, the machine must
be manually restarted.

9. Operation

General (Fig.14)
To switch on the machine, push in the green On button "I" (9); the ma-
chine starts up. To switch off , press the red Off button "O" (9); the device
shuts down.
Ensure that you do not overload the device.
If the sound of the motor drops in pitch during operation, it is being over-
loaded.
Do not overload the device to the point where the motor comes to a
standstill. Always stand in front of the machine during operation.
Inserting the tool, Fig. 1
Make sure that the power plug is removed from the socket-outlet before
changing tools. Only cylindrical tools with the stipulated maximum shaft
diameter may be clamped in the scroll chuck (12). Only use a tool that is
sharp and free of defects.
56 | GB
 www.scheppach.com /  service@scheppach.com /  +800 4002 4002