Shift Cable Inspection And Adjustment - Yamaha WaveRunner XLT800 Wartungshandbuch

INSP
ADJ
CONTROL SYSTEM
5
4

Shift cable inspection and adjustment

1. Check:
Reverse gate stopper lever position
G
Incorrect → Adjust.
Checking steps:
Set the shift lever to the reverse posi-
G
tion.
Check that the reverse gate 1 contacts
G
the stopper 2 on the bracket and the
lever 3 contacts the reverse gate.
G
Set the shift lever to the forward posi-
tion.
G
Check that the lever 4 has been
shifted over the bracket 5.
2. Adjust:
Shift cable joint
G
Adjustment steps:
Loosen the locknut 1.
G
G Disconnect the cable joint 2 from the
ball joint 3.
G Situate the reverse gate to the stopper
on the bracket and the lever to the
reverse gate.
Turn the cable joint to align it with the
G
ball joint.
Turn in
Turn out
G
Turn out the cable joint nine times a
to extend cable 7 mm (0.28 in) from
the aligned position.
WARNING
The cable joint must be screwed in more
than 8 mm (0.31 in).
Connect the cable joint and tighten the
G
locknut.
Locknut:
3 N • m (0.3 kgf • m, 2.2 ft • lb)
3-6
Shortens.
Lengthens.
E