General Guidelines When Working With Implement; Collision Safety Device; Adjusting Measurement; Mowing - Pottinger CAT DISC 17 Betriebsanleitung

General Guidelines when Working with
Implement
- The mower unit is suitable for gradients of between +30° and -20°.
Collision Safety Device
When mowing around trees, fences, boundary stones etc., collisions
between the cutter bar and obstacles can occur despite careful
and slow driving. Therefore, in order to prevent such damage,
collision protection has been planned for the cutting device.
Attention!
lt is not the intention of the collision safety device to prevent
darnage to the machine when working at full speed.
- Ovarload device (34) enables cutter bar to swing away when it
collides with an obstacle.
- The overload device is engaged again by reversing.
Adjustment:
ln case the safety device trips to easy adjust hexagonal nut.
Adjusting measurement:
CAT DISC 17 124 mm
CAT DISC21
CAT DISC25
122mm
120mm
CAT DISC 29 118 mm
CAT DISC 33
=
116 mm
lf you are not shure whether the cutting area is really
free of obstacles, please work at an appropriate slow
speed!
9600-GB EINSATZ (368) - 12-
Mowing@
Mowing
1. Horizontally set Iifting gear's lower link (Sp)
2. Close protection covers (5a)
3. Adjust cutting height
by turning upper link
spindie
- cutter disc inclination:
max. 5°
4. Set height of Iifting
gear
stop-lock support at stop
F::::::=:":::~
("Mowing" position)
5. Before mowing, throw-in p.t.o. slowly outside crop and
bring mower drums up to full speed.
Noises conditional to p.t.o. free-wheel system can be prevented
through an even continious increase in r.p.m.
- Travelling speed is set according to ground conditions and crop.